Publicité
Attach the rotary broom to the front frame as shown.
Make sure the rotary broom's hitch is pushed in until
locked into place by the springs (item 1).
Connect the driveline to the tractor's P.T.O. spline shaft.
Make sure that the yoke is securely attached to the
tractor's P.T.O.
DANGER
Do not operate without driveline completely
covered by the extension guard.
If the driveline is not completely covered, be sure
an extension guard is installed.
DANGER
ALL CONTACT WITH THE ROTATING
DRIVELINE MAY CAUSE DEATH
KEEP AWAY AND NEVER OPERATE WITHOUT:
All extension guards for the tractor and the
driveline in place.
The driveline securely attached at both ends.
Adjust the extension guard so that it is parallel with
the driveline and tighten the bolts firmly.
Make sure the extension guard does not touch
anywhere particularly when the rotary broom is
raised.
Install the handgrip (item 1) on the handle (item 2) and
slide the handle in handle support (item 3).
Install the handle on the handle extension (item 4) and
on the control rod (item 6).
Secure with the hair pins (items 5 & 7).
VERIFY TIRE PRESSURE:
Check and adjust tractor tire pressure as follows:
Front tires:
Back tires:
Tire pressure must be even on both sides of the
tractor.
ASSEMBLY
20 psi
7-8 psi
Attach rotary broom to front frame
17
Install handle
Publicité
