Publicité
1
Injector holder
2
screw
3. Pull out the injector holder.
4, Unscrew injectorby turning to counter-
clockwise direction.
5. Fit new injector.
Reduced flow adjustment for the gas oven
For the appropriate functioning of the oven re-
checking the by-pass adjustment is extremely
important. In order to provide maximum security
to the user these operations have to be done with
care.
1. Ignite the burner that is to be adjusted and
turn the knob to the high flame position.
2, Close the oven door and wait for 10 to
15 minutes until the oven becomes ready for
adjustment.
3. Take out the knob
4, After 15 minutes, adjust the oven to the
lowest flame position
5 Set the flame length to 2 to 3 mm by means
of the screw 7 on the oven tap. Turning in
clockwise direction reduces the flame,
turning counter-clockwise increases the
flame.
the temperature of the oven increases
unintendedly, turn off the oven and call the
Bauthorised service agent to have oven
thermostat repaired.
If the gas type of the unit is changed, then
the rating plate that shows the gas type of
the unit must also be changed.
Future Transportation
Keep the product's original carton and
transport the product in it. Follow the
instructions on the carton. If you do not
have the original carton, pack the product in
bubble wrap or thick cardboard and tape it
securely.
To prevent the wire grill and tray inside the
oven from damaging the oven door, place a
Strip of cardboard onto the inside of the
oven door that lines up with the position of
the trays. Tape the oven door to the side
walls.
secure the caps and pan supports with
adhesive tape.
Do not use the door or handle to lift or move
the product.
{Do not place any objects onto the product
and move it in upright position.
Check the general appearance of your
product for any damages that might have
occurred during transportation.
17/EN
Publicité
