6) The remaining solution can be used to sanitise utensils.
Note: Do not wipe dry or rinse after sanitising, but allow to air dry.
[d] Water Tank, Spray Assembly, Separator and Ice Chute Cleaning/Sanitisation (Monthly)
1) Move the power switch to the "OFF" position.
2) Unplug the icemaker.
3) Open the storage bin door, and remove all ice.
4) Remove each separator by lifting it to the horizontal position and pushing it hard
inward. Remove all the separators in the same way, and clean and sanitise them.
5) Disconnect the water pipe by the drain to remove water in the tank.
6) Spread out the tabs on both sides to unlock the water tank, and pull it out toward you.
Clean and sanitise the water tank.
7) Lift off the ice chute from the front frame pipe and then from the rear frame pipe.
Clean and sanitise the ice chute.
8) Pull the discharge tube from the spray assembly. Remove the assembly by
pulling it toward you.
9) Remove the two caps to clean and sanitise the spray assembly. If the nozzles are clogged, clean
them with a wire or a suitable brush.
Separator
Water Pipe
Frame Pipe
Discharge Tube
Spray Assembly
9
ENGLISH
Water Tank
Unlock
Pull out
Ice Chute
Unlock
Cap