Operating Instructions - Hoshizaki AM-20CAE Notice D'utilisation

ENGLISH
* A plumbing permit and services of a licensed plumber may be required in some areas.
* The icemaker drain is gravity fed, so ensure the drain hose has an adequate pitch or fall.
* Drain lines should not be installed directly to the sewer system.
* To prevent a backflow into the storage bin, the outlet hose must be laid as shown.
GOOD
Downgrade
* Be sure to use the new hose-sets supplied with the appliance. Do not reuse any old hose-sets.
1) Attach the angled end of flexible inlet hose (accessory) to the G3/4 fitting on the rear of the icemaker as indicated, ensuring
rubber sealing washer is correctly positioned. Hand tighten sufficiently to provide leak free joint.
2) Attach the other end of inlet hose to the water tap, noting that the washer is correctly positioned before hand tightening as
described above. It is a wise precaution to have a stop valve within easy reach.
3) Hand tighten grey flexible outlet hose (accessory) onto the R3/4 fitting on the rear of the icemaker as indicated, ensuring
rubber washer is correctly positioned to obtain a leak free joint. The hose can be cut to length as necessary to suit the position
of the main drain.
Inlet Hose
Outlet Hose
II. OPERATING INSTRUCTIONS
Do not put your hands into the back of the storage
bin or the ice chute on top of the storage bin.
Ice may drop off the icemaker, a hard block of
ice may suddenly break down, or the icemaking
mechanism may suddenly move, resulting in injury.
To prevent damage to the bin door, do not lean on or put anything on the door when it is open.
BAD
Upgrade
Potable Water
Inlet G3/4
Drain Outlet R3/4
CAUTION
6
BAD
Water Supply Tap
Inlet Hose
Ice Chute
Storage Bin