Publicité
SAFETY PRECAUTIONS
It is really important you read Safety Precautions Before Operation and Installation
Incorrect installation due to ignoring instructions can cause serious damage or injury.
The seriousness of potential damage or injuries is classi ed as either a WARNING
or CAUTION.
Explanation of Symbols
WARNING
This symbol indicates the possibility of personal injury or loss of
life.
CAUTION
This symbol indicates the possibility of property damage or serious
consequences.
WARNING
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by
a person responsible for their safety. Children should be supervised to ensure that
they do not play with the appliance.
ELECTRICAL WARNINGS
Only use the speci ed wire. If the wire is damaged, it must be replaced by the
●
manufacturer, its service agent or similarly quali ed persons in order to avoid a
hazard.
The product must be properly grounded at the time of installation, or electric
●
shock may occur.
For all electrical work, follow all local and national wiring standards, regulations,
●
and the Installation Manual. Connect cables tightly, and clamp them securely to
prevent external forces from damaging the terminal. Improper electrical
connections can overheat and cause re, and may also cause shock. All electrical
connections must be made according to the Electrical Connection Diagram
located on the panels of the indoor and outdoor units.
All wiring must be properly arranged to ensure that the control board cover can
●
close properly. If the control board cover is not closed properly, it can lead to
corrosion and cause the connection points on the terminal to heat up, catch re,
or cause electrical shock.
Disconnection must be incorporated in the xed wiring in accordance with the
●
wiring rules.
●
power supply can cause re or electric shock.
If connecting power to xed wiring, an all-pole disconnection device must
●
be incorporated in the xed wiring in accordance with the wiring rules.
©2024 Innovair Solutions. All Rights Reserved.
02
www.innovair.com
Publicité
