Publicité
Install the control box cover and turn the
●
circuit breaker to ON, then close the two plastic
covers on both sides of the panel.
During the test-run process, the display will be
●
lighted and the air griller will rise automatically.
Model B
Press the circular position to open the two screw
●
covers, then remove the two screws.
Hold and open the air grille, then push both of the
●
latch to the middle to unlock the air grille.
Pull the panel grille out of the panel, x the
●
cassette panel to the one-way cassette by two
plastic buckles.
©2024 Innovair Solutions. All Rights Reserved.
Screw Covers
Latch
Manually rotate the air de ector, x the panel
●
to the cassette by using 3×M4*22 screws and a
ST3.9*16 screw.
M4*22 screw
NOTE:
Eight M4*22 screws are supplied,
two of which are spare. Two
ST3.9*16 screws are supplied, one
of which is spare.
Before xing this screw, you need to open the screw
cover; and after xing screw, please close the cover.
Open the two covers on both sides of the panel,
●
x the panel to the cassette by using 3× M4*22
screws.
Connect the display board to the main control
●
board, up to four wires are required to connect.
NOTE: The corresponding colors or corresponding
pins are connected each other.
CN10
(white 10-core)
CN55
(red 5-core)
when connection is completed, please
clip the wires to the buckle.
34
palstic buckle
ST3.9*16 screw
M4*22 screw
CN14
(white 5-core)
Wireless
CN38
(4 core)
www.innovair.com
Publicité
