Publicité
NOTE ON CIRCUIT BREAKER
When the maximum current of the air conditioner is more than 16A, a circuit breaker or leakage
protection switch with protective device shall be used (purchased separately). When the
maximum current of the air conditioner is less than 16A, the power cord of air conditioner shall
be equipped with plug (purchased separately). In North America, the appliance should be
wired according to NEC and CEC requirements.
Circuit breaker
(purchased separately)
Outdoor unit power wires
Outdoor unit
Circuit breaker
(purchased separately)
OUTDOOR UNIT WIRING
WARNING
1.
Prepare the cable for connection
a. You must rst choose the right cable size.
Choose the cable type according to the
local electrical codes and regulations.
b. The size of the power supply cable, signal cable,
fuse, and switch needed is determined by the
Minimum Circuit Ampacity of the unit.
The Minimum Circuit Ampacity is indicated on
the nameplate located on the side panel of the
unit. Refer to this nameplate to choose the
right cable, fuse, or switch.
c. Using wire strippers, strip the rubber
jacket from both ends of the signal cable
to reveal approximately 5.9in (150mm) of
wire.
d. Strip the insulation from the ends.
e.
Using a wire crimper, crimp u-lugs on
the ends.
NOTE: When connecting the wires, strictly
follow the wiring diagram found inside the
electrical box cover.
©2024 Innovair Solutions. All Rights Reserved.
Indoor & Outdoor
connective wires
(purchased separately)
Indoor unit
28
NOTE: The cographs are for explanation
purpose only. Your machine may be slightly
2.
Remove the electric cover of the outdoor
unit. If there is no cover on the outdoor
board and remove the protection board.
3.
Connect the u-lugs to the terminals
Match the wire colors/labels with the labels
on the terminal block. Firmly screw the u-lug
of each wire to its corresponding terminal.
4. Clamp down the cable with the cable clamp.
5. Insulate unused wires with electrical tape.
Keep them away from any electrical or metal
parts.
6. Reinstall the cover of the electric control
box.
Cover
Screw
www.innovair.com
Publicité
