Publicité
PANEL INSTALLATION
Step1: Prepare and install ceiling
Drill 16.93in x51.18in (430 mm x 1300 mm )
●
hole into the ceiling based on the layout of
the installation board.
The center of the ceiling opening should
match the center of the body of the indoor
unit.
NOTE:
In order to keep the ceiling level and
prevent vibrations, reinforce the strength
of the ceiling when necessary.
Once the ceiling is cut, remove the
●
installation board. then install the ceiling.
Step2: Panel Installation
Model A
NOTE:
The air grille received by the customer is not
tightened by the wire rope, but is specially
designed to be loose for easy installation.
Grab air grille with your ngers and pull it out
●
slowly in the direction of the arrow.
Grab at these locations
Pull the panel grille out of the panel, x the
●
cassette panel to the one-way cassette by two
plastic buckles.
Manually rotate the air de ector, x the panel
●
to the cassette by using 3×M4*22 screws and
a ST3.9*16 screw.
©2024 Innovair Solutions. All Rights Reserved.
M4*22 screw
NOTE:
Eight M4*22 screws are supplied,
two of which are spare. Two
ST3.9*16 screws are supplied, one
of which is spare.
Before xing this screw, you need to open the screw cover;
and after xing screw, please close the cover.
Open the two covers on both sides of the panel, x
●
the panel to the cassette by using 3× M4*22 screws.
M4*22 screw
Connect the display board to the main control
●
board, up to four wires are required to connect.
NOTE:
The corresponding colors or corresponding pins
are connected each other.
CN10
(white 10-core)
CN55
(red 5-core)
when connection is completed, please clip
the wires to the buckle.
33
ST3.9*16 screw
CN14
(white 5-core)
Wireless
CN38
(4 core)
www.innovair.com
Publicité
