Publicité
Connect the wire to the terminal according to
the wire connecting diagram.
Fix the wire with the clip by using the two screws.
©2024 Innovair Solutions. All Rights Reserved.
Select one to
connect ground
wire
TO INDOOR UNIT
1
2
3
TO OUTDOOR UNIT
Install the terminal cover by xing the two screws.
2. Install the indoor air handler
NOTE:
After you have nished installing the main body,
when choosing where to start, determine the
direction of the pipes to be drawn out.
Especially in cases where there is a ceiling
involved, align the refrigerant pipes, drain pipes,
and indoor and outdoor lines with their
connection points before mounting the unit.
After you selecting an installation location, drill
a hole with the diameter of 6mm or less into
the roof beam based on the layout of the
installation board (accessory Installation
cardboard template). After drilling the hole,
remove the installation board.
16.93in
(430mm)
Installation cardboard template
Connecting the wire from the control box.
To CCM
Comm. Bus
E
X
Y
CN3
MAIN CONTROL
BOARD
16
Two screws
51.18in (1300mm)
NON-POLARITY
WIRED-CONTROLLER
MAGNETIC RING
HB HA
C N 41
www.innovair.com
CUTTING LINE
Publicité
