Publicité
If you are installing the outdoor unit on the ground, or a concrete mounting platform, use the
following steps:
1. Mark the positions for four expansion bolts based on dimensions in the Mounting Dimensions
chart and illustrations above.
2.Pre-drill holes for expansion bolts.
3.Clean concrete dust away from the holes.
4.Place a nut on the end of each expansion bolt.
5.Hammer expansion bolts into the pre-drilled holes.
6.Remove the nuts from the expansion bolts, and place outdoor unit on bolts.
7.Put a washer on each of the expansion bolts, then reinstall the nuts.
8.Using a wrench, tighten each nut until snug.
WARNING
WHEN DRILLING INTO CONCRETE, EYEPROTECTION IS RECOMMENDED AT ALL TIMES.
If you are installing the unit on a wall-mounted bracket, follow these steps:
CAUTION:
Before installing a wall-mounted unit, make sure that the wall is made of solid brick, concrete,or a
similarly strong material. The wall must be able to support at least 4 times the weight of the unit.
1. Mark the position of the bracket holes based on the dimensions in the Mounting Dimensions chart on the
previous page.
2.Pro-drill the holes for the expansion bolts.
3.Clean dust and debris away from the holes.
4.Place a washer and nut on the end of each expansion bolt.
5.Thread expansion bolts through the holes in the mounting brackets. Then, put the mounting brackets in
position and hammer the expansion bolts into the wall.
6.Check that the mounting brackets are level.
7.If the feet of the outdoor unit have rubber pads already installed , and you are using a local dealer's
wall-mounting bracket, remove them before attempting to mount the condenser to the bracket. The
mounting bracket has rubber isolating pads on it that will take the place of these.
8.Carefully lift the unit and place its mounting feet on the brackets.
9.Then,bolt the unit rmly to the brackets.
TO REDUCE VIBRATION OF WALL-MOUNTED UNIT
If allowed, you can install the wall-mounted unit with rubber gaskets to reduce
vibration and noise.
©2024 Innovair Solutions. All Rights Reserved.
21
www.innovair.com
Publicité
