Setting The Reverb Effect - Viscount Prestige VIII - IX Mode D'emploi

Viscount PRESTIGE VIII - IX
As already mentioned, the MASTER parameter regulates the general volume of the organ's internal amplification; the
encoder can be turned to select a value between 1 and 64.
As well as the Master parameter, the video page offers the volume values relating to the pedal keyboard and each individual
manual: these consist of two values (separated by the "+" symbol), where the first represents the base volume of the manual
and the second the increase provided by the expression pedal. Only the first value can be modified using the control unit,
since the second is updated during operation of the pedal themselve.
Õ Ö
To modify the values, press the CURSOR and keys until the flashing cursor locates on the value to be modified, then
turn the encoder both ways until the desired value is reached.
ENCODER
CURSOR Keys
The values selected can be saved if required in one of the general or dedicated memories, following the procedures
described in section 2 of this manual.

3.3 SETTING THE REVERB EFFECT

To set the reverb effect, press the REVERB key in the general functions section of the control unit.
The message "DIGITAL REVERB" will appear on the alphanumeric display followed by the status (ON or OFF) and the
general LEVEL of the effect.
     ,
#4#* ;>
Then use the cursor keys to move the flashing cursor to the parameters to be modified; the encoder knob can be used to vary
the value of the selected parameter.
REVERB Key
36