Publicité
FITTING INSTRUCTIONS
Starting from the Left hand side of the bike, remove the three bolts arrowed in
picture 1 and gently remove the side panel. Repeat the procedure for the RHS
panel.
Remove the black plastic cover that is positioned in front of the fuel filler cap, as
arrowed in picture 2.
Remove the four bolts arrowed in picture 3. Remove both top side panels off by
gently sliding them forward.
Starting from the LHS, Remove the two bolts arrowed in picture 4. Repeat the
procedure for the RHS.
Remove the three bolts located below the front beak (arrowed in picture 5).
Remove the cover (labelled A in picture 5).
Remove the front beak assembly by gently sliding it forward. Be aware that the
air pressure sensor connector is located on the front beak unit, this needs to be
disconnected before removal.
Take the rubber trim supplied and cut in half, fit them on both edges of the oil
cooler guard mount as shown in picture 6.
Remove the OEM rubber grommet (labelled B in picture 6) to allow oil cooler
guard fitment as shown in picture 7.
From the kit, cut the foam strip provided into 10mm wide pieces and stick them
to the back of the oil cooler guard frame, so they sit between the oil cooler
guard and the oil cooler unit.
Slide the oil cooler guard in place as shown in picture 8. Secure the oil cooler
guard using two cable ties provided in the kit. Use the cable ties on both top
mounts of the oil cooler guard onto the OEM oil cooler unit.
Re-fit the OEM rubber grommet removed earlier.
Offer the front beak up to the bike and re-connect the air pressure sensor
connector. Fit the front beak and its lower cover as original.
Fit both top side panels as original and secure with two bolts on each side of the
panel.
Fit the black plastic cover in front of the fuel filler cap as original.
Fit the metal side panels as original.
Ensure all bolts are tight and the bodywork is correctly mounted.
Digital copies of these instructions are available to download from
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
Issue 2 13/06/2016 (HH)
R&G Racing
www.rg-racing.com
www.rg-racing.com
Email:
info@rg-racing.com
Publicité
