S&P INFRARED 120 N Manuel D'installation Et D'utilisation page 9

- WARNING: This heater is not equipped with a device of room temperatu-
re control. Do not use this heater in small rooms that are occupied by peo-
ple who can not leave the room by themselves, unless ongoing monitoring
is assured.
- The product must be installed respecting the minimum distances from
ceiling, floor and objects at the sides indicated in picture 1.
- The heater must be installed at a minimum height of 1,8 m above the
ground, as shown in Figure 1.
- If the cable gets damaged it must be replaced by S&P – take the equip-
ment to our official S&P dealer because the work must be done by specia-
list personnel to avoid any risk of damage.
- Do not use this heater with a programmable switch, timer or any auto-
matic switching device because of danger and/or fire hazard if the heater
is covered.
- This infrared wall mounted heater is only suitable for mounting horizon-
tally on a solid vertical wall. Never install it vertically or on the ceiling as
indicated in picture 2.
- The product must not be mounted on any inflammable surface such as
wood or plastic.
- WARNING: Flammable objects (curtains, furniture, plants, etc.) should
not be placed at less than 2 meters from the appliance.
- the appliance must not operate in rooms where danger can arise from
explosive gases or where inflammable materials are being used, such as
wood block or PVC flooring is being laid or sealed.
- Care should be taken to mount the appliance so that the product and
the pull cord switch are out of the reach of children. If it is installed in a
bathroom, it should be positioned so that it cannot be touched by anyone
who is in the bath or in the shower.
- the safety zones defined by your local electrical installation Standards or
the Safety regulations applicable in your country are to be exactly obser-
ved. In any case never install the heater inside the patterned areas called
ZONE 0, 1 and 2 shown in picture 3.
- After use we recommend to leave the product cool down for at least 10 –
15 minutes before touching it.
- Before the appliance is started up for the 1st time check that all the plas-
tic pieces used in the packaging or to protect the tube element have been
removed.
9