Installation On Tension Bar; Adjusting The Headrest Support; Lower And Upper Sections Depth Adjustment - Physipro Symbio Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ENGLISH

4. Installation on Tension Bar

4.1 Align the adapter A into the interior of
the rod with the bracket B.
4.2 Install the bracket screws and nuts as
shown.

5. Adjusting the Headrest Support

5.1 Align headrest tube with the hole in the mounting
bracket and slide into mounting bracket on back.
5.2 Adjust the headrest hardware to the desired position
and secure in place by tightening the seat back
mount handle A.
5.3 To adjust the height, slide the locking ring B against
the bracket and tighten.

6. Lower and Upper Sections Depth Adjustment

6.1 Loosen screws (M6) and rotate the horizontal adjustment joint to let the depth
adjustment tube slide freely.
6.2 Adjust the headrest to the desired
position.
A
Lower Pivot
4
Symbio headrest
B
B
A
Upper Pivot

Publicité

Table des Matières
loading

Table des Matières