Publicité
9
Operation
(Instructions to operate each function)
Nozzle position adjustment
• When using the wash functions use
(front),
•
LED level
Front
l
Back
TM
TM
Warm air dryer adjustment
• The display lamp for the Water pressure / Dryer will change when using the dryer function.
• Adjust the dryer temperature by pressing
(Strong),
• The drying functions can be adjusted up to 5 levels.
•
LED level
Strong
l
Weak
TM
TM
Oscillate
• After pressing one of the wash functions: REAR / FRONT / TURBO, pressing it
a second time will activate the oscillating nozzle, covering a wider area of washing.
• Press the button once more to stop the oscillation.
Automatic self cleaning nozzle
• Before and after using REAR, FRONT,
TURBO the nozzle will automatically clean itself.
16
(back) buttons to adjust the nozzle to fit to your body.
Front
l
Back
(Weak).
Strong
l
Weak
Energy saver
• When pressing
(eco mode) the energy saver light on the
electronic toilet seat will turn on.
• Energy saver mode automatically maintains a water and
seat temperature of 89.6°F.
• If you want to turn off the energy saver function,
TM
press the
(eco mode) button again and the display light
will turn off.
During a power outage, the water or seat heating temperature could appear to be lower than
the actual temperature setting.
TM
Other energy saving tips
In order to save energy, please abide by the following instructions:
• Keep seat cover closed when not in use to prevent heat from being lost.
• Keep temperature set to low.
• Unplug the power cord if you do not plan to use it for a long period of time.
Setting up and using the remote control
• Select a convenient spot near the toilet to attach the remote control holder.
• Make sure that the selected spot will not be exposed to water and the area where you intend to
affix the holder is clean and dry.
• Remove film from the double sided tape locaed on the back of the remote control holder and
place the holder in the selected area.
• On remote control insert the three(3) batterries (1.5V AAA) ensuring that the poles on the batteries
correspond to the diretions on the remote control.
Three (3) batteries
( + , - please consider the right polarity)
• Always purchase the correct size and grade of battery most suitable for the intended use.
• Clean the battery contracts and also those of the device prior to battery installationj.
• Remove batteries frome equipment which is not to be used for an extended period of time.
• Remove and replace all batteries.
Double sided tape
TM
TM
Remote control holder
E
N
G
L
I
S
H
17
Publicité
