Publicité
5
Installation
• This product requires 120V usage.
• Please do not plug in the electrical cord prior to installation.
• Please consult with a licensed electrician if electrical work is needed, and in case a grounded outlet
is not available, grounding should be done in order to prevent short circuits or electric shock.
Installation steps
1
Shut water supply by turning it to the right.
Water supply hose
3
Connect the water supply hose to the
assembled T-valve.
10
Caution
2
Disconnect existing hose from water tank.
Connect the T-valve to the water tank.
Water Tank
T-valve
(with packing)
Shut off Valve
4
Remove existing seat and lid.
• Release the bolts on both
Exisiting toilet
sides of the existing toilet
seat
seat to remove the seat
and lid.
• Store the removed seat,
Toilet
Nut
body
nut and water hose in a
safe area in case you
move or it needs to be
reinstalled.
5
Place the bolt into the bolt case and align it with the
top of the base plate. Insert the bolt with bolt case onto
the base plate. After this is done, hold the bolts, gently
slide it into the bottom of the unit until it clicks in place.
You will hear a click sound. Please do NOT use force.
Base plate
Bolt
Installed bolt case
7
Once the base plate is attached to the unit, align the
unit and toilet fixture facing front, and then insert the
mounting bolts to the toilet mounting holes. Please do
not over tighten the nut.
Back
Bolt
Cone Packing
Nut
6
Install the main unit and insert the mounting
bolts to the toilet mounting holes.
Cone Packing
Nut
8
Connect the flexible tube from side of
T-valve to the unit. Turn the water
valve to the left to allow water to flow.
Bidet hose
Water supply valve
※ Customers should use the new hose set provided
with the product. Do not use used set again.
E
N
G
L
I
S
H
11
Publicité
