Télécharger Imprimer la page

SmartBidet SB-1000 Guide D'utilisation Et Manuel D'installation page 10

Bidet électronique

Publicité

10
Maintenance
Cleaning the body unit
• Beware to not use any bathroom cleaning detergents such as benzene acid
chemical detergent on the seat exterior.
- Using any type of chemical products or rough scrubbers on the electronic toilet seat surface,
which is made out of plastic material can either damage or change its color.
• Do not spray water directly or use a shower hose on the main body unit.
- Can cause fire or damage to the unit.
• When cleaning, the power cord must be unplugged from the power outlet,
and make sure water does not contact the cord and/or outlet.
• After cleaning, use a soft cloth to dry the unit.
Do not use cleaning products or chemical detergent. We recommend to mix baking powder and
water or vinegar and water to clean the unit.
Cleaning the nozzle
• Please perform the actions below without sitting on the toilet seat.
- On Remote controller press and hold the 'STOP' button for three (3) seconds and the water nozzle will extend.
- To clean use a soft bristled brush(tooth brush) or a soft cloth. Upon completion press and hold the'STOP'
button and the nozzle will retract back to its original position and will perform it's self-cleaning function.
- Upon completion of these two steps the toilet seat can be used.
Cleaning the water filter(strainer)
① Close the water shut off valve.
② Flush the toilet to empty the water reservoir.
③ Unscrew the water hose nut.
④ Clean the strainer with a small brush or water.
⑤ Re-screw the water hose nut.
⑥ Open the water shut off valve.
18
Water filter
Water supply valve
(Strainer)
11
Draining water from tank
1
Disconnect the power plug.
2
Shut the valve by turning it to the right.
3
When pressing the drain button located on the side of the body unit,
the water in the tank will completely drain into the toilet bowl.
• This electronic toilet seat has considered the user's
convenience in that the water can be drained easily
without removing the unit from the toilet seat.
12
Maintenance for winter season
1
Check if the power cord is plugged in securely.
2
Adjust the
(water temp) button to "low" to prevent water from freezing.
3
If the product is not used for a long period of time,
please disconnect the power cord and
drain the water from the internal unit.
TM
4
Please do not keep this product outdoors during the winter
as the cold temperature may damage the product.
E
N
G
L
I
S
H
Water supply valve
Drain button
19

Publicité

loading

Produits Connexes pour SmartBidet SB-1000