Publicité
13
Trouble shooting
※ Please be sure to check the following aspects before asking for help.
Troubleshooting
• Check if the water tank is filled.
The water does not spray
• See if the water valve is closed.
• Check if the water filter (strainer) is clogged.
• Check if the power cord is connected.
• See if the power is turned off from the main unit.
The unit is not operating
• See if you are correctly sitting on the seat so that the skin sensor switch will
function properly.
(Make sure that the Skin sensor on the seat touches your skin when you sit on the seat.)
• After checking if the plumbing is correctly connected, if water is leaking
Water is leaking
from the main unit disconnect and contact service personnel.
• Check if the water pressure is set at 'low'.
Water pressure is weak
• Check if the water filter (strainer) is clogged.
Seat, water and
• See if the water temperature is set to 'low'.
dryer is not warm
• Check if the dryer temperature is set to 'low'.
When the nozzle doesn't
• See if the skin sensor on the seat is touching the skin.
come out
• Adjust the temperature to (mid, high).
When water is cold or warm
• If someone has already used the wash function, wait about 3 minutes to use it.
• Sit on the seat for approximately 3 minutes and then use it.
Body unit shakes
• Tighten the bolt.(do not over-tighten)
Dryer does not work
• See if the skin sensor on the seat is touching the skin.
20
Factors to check
14
Specifications
Specification
Power rating
Type
Water
inlet type
Water inlet pressure
TURBO
FRONT
REAR
Water pressure
Wash
adjustments
device
Warm water temperature
control
Heater
Safety device
Temperature control
Heated
Heater
seat
Safety device
Warm air control
Warm Air Dryer
Heater
Device
Safety device
Inlet water temperature
Ambient temperature
Dimensions
W : 17.3inch (440mm)
L : 20.6inch (525mm)
H : 7.13inch (181mm)
Weight (Ibs)
N.W. : 10.4 lbs (G.W. : 15.4 lbs)
※ The design and function of this product could be changed without notice for the improvement of its quality.
SB-1000
120V / 60Hz / 660W
Direct Inlet Flow Type
0.07 ~ 0.74Mpa(0.7 ~ 7.5 kgf/cm²)
Max. 700cc ± 150cc / min.
Max. 700cc ± 150cc / min.
Max. 700cc ± 150cc / min.
5 levels
Room Temp. ~ Low, Normal, High
600W
Thermal fuse, Thermal switch, Float switch
Room Temp. ~ Low, Normal, High
55 W
Thermal fuse, Bimetal
Room temp ~ 131°F , 5 levels
250W
Thermal fuse, Bimetal
37.4 °F ~ 95°F (3°C ~ 35°C)
37.4 °F ~ 104°F (3°C ~ 40°C)
Elongated
Round
W : 17.3inch (440mm)
L : 19.4inch (493mm)
H : 7.13inch (181mm)
N.W. : 10 lbs (G.W. : 15.4 lbs)
E
N
G
L
I
S
H
21
Publicité
