SICK PFT Mode D'emploi page 30

Operating Instructions
Functional test
The output signal must be proportional to the pressure. If not, this might point to a damage of
the diaphragm. In that case refer to chapter 10 „Troubleshooting".
Open pressure connections only after the system is without pressure!
„
Observe the ambient and working conditions outlined in section 7 „Technical
„
data".
Warning
Please make sure that the pressure transmitter is only used within the overload
„
threshold limit at all times!
When touching the pressure transmitter, keep in mind that the surfaces of the
Caution
instrument components might get hot during operation.
30
7. Starting, operation
© SICK AG • Germany • All rights reserved
PFT
GB
8013155/ZZV8/2018-06-25