Publicité
Battery holder
Battery
•
Place the holster on the adjustable waist belt.
Holster
Adjustable
waist belt
•
The adjustable waist belt must be fi xed to the operator's waist, with the
battery holder positioned at the rear (back) and the buckle at the front.
Buckle
Battery
holder
•
Use the smaller buckle to adjust the waist belt size as desired.
Arm bracelet
Jacto
PB-25
Holster
Adjustable
waist belt
Buckle
Waist belt
•
Attach Jacto PB-25 cable to the guide buckles, the adjustable waist
belt, and the arm bracelet.
Guide buckle
WARNING!
Only use the equipment with the cable secured in the guide
buckles. Using the equipment with the cable unsecured can
pose risks to the operator and the integrity of the product.
10. Operating Instructions
Before using Jacto PB-25, reading and understanding the instructions below is
mandatory.
Jacto PB-25's operation is based on a system of two levers that allow the cutting
of wood materials. The cut must be made in a direction perpendicular to the
fi bers. The equipment must only be used with the right hand. Structurally, Jacto
PB-25 consists of two blades (one called "cutting blade" and the other "counter
blade"), one of which is fi xed and the other movable.
The cutting blade's rotation base is on the counter blade, which allows a 55º
rotation. The movement of the cutting blade is provided by an electric motor
located inside the fairing, powered via an electrical cable by a low-voltage bat-
tery carried by the operator in a battery holder. This command is executed by
pressing Jacto PB-25 trigger securely positioned in the hand with your fi nger.
WARNING!
The manufacturer, importer, or dealer is not responsible for
accidents, injuries, or damage to people, animals, or property
caused by failure to comply with this manual's safety and
accident preventions.
10.1. Turning on and operating the equipment
After unpacking the product, ensure there is no damage and check the presence
of safety stickers; proceed as indicated:
•
Remove the equipment and its components from the packaging with
the battery support. As item "6.1. Recharge procedure" explains, fully
recharge the battery before use.
•
Carry out the assembly as described in item "9.2. Assembling".
To turn on Jacto PB-25, press and hold the "on/off " button until you hear a con-
tinuous beep. The display will show the product name (PB-25) and the total cuts
accumulated on the initial screen for 2 seconds.
On/off button
Boot screen.
Cable
Operation screen.
25/66
Publicité
