Stiebel Eltron BGC Utilisation Et Installation page 12

operation
safety
2. safety
2.1 intended use
The appliance is intended for installation in cylinders in a sealed
heating or DHW heating system.
Any other use beyond that described shall be deemed inappropri-
ate. Observation of these instructions is also part of the correct
use of this appliance. Any modifications or conversions to the
appliance void all warranty rights.
It is also incorrect to use the appliance to heat liquids other than
water, or water containing chemicals such as brine.
2.2 general safety instructions
DANGER Electrocution
Never spray the appliance with water or other liquids
DANGER Burns or scalding
Bei Temperatur-Einstellung größer 43 °C kann sofort
Wasser hoher Temperatur fließen.
WARNING Injury
!
Sollten Kinder oder Personen mit eingeschränkten
körperlichen, sensorischen oder geistigen Fähigkeiten
das Gerät bedienen, stellen Sie sicher, dass dies nur
unter Aufsicht oder nach entsprechender Einweisung
durch eine für ihre Sicherheit zuständige Person ge-
schieht.
Beaufsichtigen Sie Kinder, um sicherzustellen, dass sie
nicht mit dem Gerät spielen.
Note
While the threaded immersion heater is in use, the cyl-
inder is under mains water pressure.
During the heating process, expansion water will drip
from the safety valve. If water continues to drip when
heating is completed, please inform your heating con-
tractor.
2.3 ce designation
The CE designation shows that the appliance meets all essential
requirements according to the:
- Electromagnetic Compatibility Directive
- Low Voltage Directive
2.4 test symbols
See type plate on the appliance.
3. equipment description
The appliance heats DHW electrically. You can adjust the tempera-
ture using the temperature selector. Once the selected tempera-
ture has been reached, the appliance switches off and restarts
automatically when required.
12 | Bgc
4. settings
The temperature is infinitely adjustable. Temperature selection is
limited at the factory and can be adjusted by the heating contractor
(see chapter "Installation / Settings").
You can interrupt the heating process by setting the temperature
selector to "cold" (see figure).
5. cleaning, care and maintenance
f If the appliance is installed in a DHW heating system, please f
note that almost every type of water deposits limescale at
high temperatures. Limescale builds up on the heating ele-
ment in particular and has to be removed occasionally by the
heating contractor.
f Always take the increased anode wear into consideration f
when using the threaded immersion heater in cylinders with
protective magnesium anodes. Protective anodes and heating
elements should be checked after approx. one year.
6. troubleshooting
fault cause
The water does not There is no power.
heat up.
The temperature is incor-
rectly adjusted.
If you cannot remedy the fault, notify your heating contractor. To
facilitate and speed up your enquiry, please provide the serial
number from the type plate (no. 000000-0000-000000):
BGC
» remedy
Check the fuse/MCB in
your fuse box/distribu-
tion panel.
Check the temperature
selection.
Nr.: 000000 - 0000 - 000000
Made in Germany
www.stieBel-eltron.com