Publicité
Speed adjusting dial
CAUTION:
Do not operate the tool contin-
uously at low speeds for a long time. Otherwise
the motor will get overloaded, resulting in tool
malfunction.
CAUTION:
The speed adjusting dial can be
turned only as far as 5 and back to 1. Do not force
it past 5 or 1, or the speed adjusting function may
no longer work.
The belt speed can be adjusted between 120 m and
470 m per minute (390 - 1,540 ft/min) by turning the
speed adjusting dial to a given number setting from 1
to 5.
Higher speed is obtained when the dial is turned in the
direction of number 5; lower speed is obtained when it
is turned in the direction of number 1. Select the proper
speed for the workpiece to be sanded.
1
Fig.7
► 1. Speed adjusting dial
Constant speed control
Electronic speed control for obtaining constant speed.
This feature enables the fine finish because the tool
speed remains constant even under load.
Accidental re-start preventive
function
Even if you install the battery cartridge while pulling the
switch trigger, the tool does not start.
To start the tool, first release the switch trigger and then
pull the switch trigger.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing sanding belt
Installing sanding belt
CAUTION:
When installing the sanding belt,
make sure that the direction of the arrow on the
back of the sanding belt corresponds to the one
on the tool.
1.
Pull the lever all the way out.
Fig.8
► 1. Lever
2.
Install the sanding belt to the rollers so that the
direction of the arrow on the back of the sanding
belt matches the direction of the arrow on the tool,
then return the lever to its original position.
4
3
Fig.9
► 1. Sanding belt 2. Roller 3. Arrow (on the tool)
4. Arrow (on the back of the sanding belt)
9 ENGLISH
1
1
2
Publicité
