Publicité
2
Fig.3
► 1. Switch trigger 2. Lock-off lever
For continuous operation, pull the switch trigger while
pushing the lock-off lever upward and then push in the
lock-on button. After that, release the switch trigger with
the lock-on button pushed in.
To stop the tool from the locked switch position, pull the
switch trigger fully, and then release it.
Fig.4
► 1. Lock-on button
Front handle
The angle of the front handle can be adjusted in 4 steps
of 30°.
To adjust the angle of the front handle to a comfortable
working angle, loosen the clamping knob. Set the angle
of the front handle and tighten the clamping knob.
1
1
2
Fig.5
► 1. Front handle 2. Clamping knob
Lighting up the front lamp
CAUTION:
source of light directly.
The lighting direction can be adjusted in three levels.
Pull the switch trigger to turn on the front lamp. To turn
off, release it. The front lamp goes out approximately 10
seconds after releasing the switch trigger.
1
1
Fig.6
► 1. Front lamp
NOTE: When the tool is overheated, the light flashes
for one minute. In this case, cool down the tool before
operating again.
NOTE: Use a dry cloth to wipe the dirt off the lens
of the lamp. Be careful not to scratch the lens of the
lamp, or it may lower the illumination.
8 ENGLISH
Do not look in the light or see the
Publicité
