Publicité
Installing or removing sanding shoe
1.
Align the holes on the slide plate with the screw
holes on the tool and secure the slide plate with
the screws.
4
3
Fig.19
► 1. Slide plate 2. Screw 3. Screw hole 4. Phillips
screwdriver
2.
Set the lock lever to the free position as shown
in the figure and insert the four protrusions of the
base into the four grooves of the tool.
2
3
Fig.20
► 1. Lock lever 2. Protrusion 3. Groove
3.
Turn the knob of the sanding shoe to adjust the
position of the locking pin so that the locking
pin goes through the slide plate as shown in the
figure.
2
1
1
Fig.21
► 1. Knob 2. Locking pin 3. Slide plate
4.
Turn the lock lever in the direction of the arrow as
shown in the figure.
1
Fig.22
► 1. Lock lever 2. Knob
5.
Turn the knob clockwise to fix the sanding shoe to
the tool.
6.
Make sure that the sanding shoe does not wobble.
If the sanding shoe wobbles, turn the knob again.
To remove the sanding shoe, follow the installation
procedures in reverse.
13 ENGLISH
2
3
2
1
Publicité
