Publicité
2.
Insert the rod part of the clamp into the hole on the
tool so that the plate part of the clamp is between
the tool and the workbench or the spacer. Then
tighten the clamping knob.
—
When spacer is not used
1
5
Fig.15
► 1. Front handle 2. Rod part 3. Hole 4. Plate part
5. Workbench 6. Clamping knob
—
When spacer is used
1
2
7
Fig.16
► 1. Front handle 2. Rod part 3. Hole 4. Plate part
5. Workbench 6. Spacer 7. Clamping knob
3
6
3
4
3.
Align the holes on the guide rule with the screw
holes on the tool and secure the guide rule with
the butterfly screws.
4
2
4
Fig.17
► 1. Guide rule 2. Hole 3. Screw hole 4. Butterfly
screw
To remove the guide rule, follow the installation proce-
dures in reverse.
Operation with clamp and guide rule
Turn on the tool and let it run continuously. Wait until the
sanding belt attains full speed, then sand by pressing
the workpiece against the sanding belt while holding the
workpiece firmly.
Never force the workpiece. Excessive pressure may
6
cause the motor to stall, overheat, burn out the work-
piece, and kickback.
5
Fig.18
Operation with sanding shoe
Optional accessory
The sanding shoe readily allows you to sand work-
pieces more evenly.
12 ENGLISH
2
1
3
Publicité
