AEG HK634030FB Notice D'utilisation page 46

Problem
Residual heat indicator does not
come on.
Automatic Heat Up does not op‐
erate.
There is a dark area on
the multiple zone.
The control panel becomes hot to
the touch.
comes on.
and a number come on.
comes on.
8.2 If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre. Give the data from the rating
plate. Give also three digit letter code for the
glass ceramic (it is in the corner of the glass
surface) and an error message that comes
9. TECHNICAL DATA
9.1 Rating plate
Model HK634030FB
Typ 60 HAD 53 AO
Ser.Nr. .................
AEG
46 ENGLISH
Possible cause
The zone is not hot because it oper‐
ated only for a short time or the sen‐
sor is damaged.
The highest heat setting is set.
The zone is hot.
You decreased the heat setting to 0.
It is normal that there is a dark area
on the multiple zone.
The cookware is too large or you put
it too close to the control panel.
Child Safety Device or Lock oper‐
ates.
There is an error in the hob.
The second phase of the power sup‐
ply is missing.
on. Make sure, you operated the hob
correctly. If not the servicing by a service
technician or dealer will not be free of charge,
also during the warranty period. The
information about guarantee period and
Authorised Service Centres are in the
guarantee booklet.
PNC 949 492 125 02
220 - 240 V 50 - 60 Hz
Made in: Romania
6.4 kW
Remedy
If the zone operated sufficiently long to
be hot, speak to an Authorised Service
Centre.
The highest heat setting has the same
power as the function.
Let the zone become sufficiently cool.
Start from 0 and increase the heat set‐
ting.
Put large cookware on the rear zones,
if possible.
Refer to "Daily use".
Deactivate the hob and activate it
again after 30 seconds. If
on again, disconnect the hob from the
electrical supply. After 30 seconds,
connect the hob again. If the problem
continues, speak to an Authorised
Service Centre.
Check if the hob is correctly connected
to the electrical supply. Remove the
fuse, wait one minute, and insert the
fuse again.
comes