Publicité
Marking
The product carries the following marks:
Input voltage xxV
Required voltage frequency (e.g. 50Hz)
The marks and
and
The manufacturer is not responsible for any damage ensuing from faulty connection of the appliance.
1.3 INSTALLATION (SPARE PARTS & MAINTENANCE MANUAL)
This dishwasher is delivered with water inlet and outlet hoses.
According to its construction, the connection of the machine to water and power supply must be performed by
an authorized and locally recognized installer by keeping the existing specifications.
Before connecting the appliance, check that the connection data on the data plate (voltage and connected
load) match the mains electricity supply.
1.3.1 INSTALLATION SUGGESTIONS
•
Open the package. Before setting up the appliance, check it for any externally visible damage due to
transportation. If in any doubt, call for a specialist to check it (from the authorized local dealer who sold
the appliance).
•
Place the dishwasher at the installation area, close to the necessary water and power supply (the ground
should be sufficiently stable).
•
The appliance should be placed horizontally. Possible inclinations should be corrected using a spirit level.
•
Following the successful installation, the dishwasher should be cleaned thoroughly with a conventional
detergent before it is put into operation.
1.4 CONNECTION TO THE WATER SUPPLY
ATTENTION: The connection with the water supply should be made according to the current safety standards.
The dishwasher may be connected to water supply with maximum inlet temperature 60°C. In case you need
connection with water supply of high temperature please contact our Factory or our distributor or our local
dealer.
•
The water supply hose should have a flap valve (non-return valve) according to DIN 1988.
•
The water supply hose/pipe should be rinsed before the appliance's connection.
•
The water supply hose/pipe should have a minimum internal diameter of 16 mm and the connection with
the hose should be 3/4 inch.
•
All hose collars should be adjusted in a fixed position before the appliance is put into operation.
ATTENTION: The water pressure must be between 2 and 5 bar.
1.4.1 DRAINAGE CONNECTION
The outflow is accomplished through gravity force (natural flow). The outlet hose should be connected either
directly to the main drainage - where a pipette for odours is anticipated, or water runs directly to a drainage
well in the ground, which has a pipette for odours.
ATTENTION: The outlet hose should not be placed higher than a level (as given for each appliance's type) from
the lower side of the dishwasher's dispenser.
www.combisteel.com
6
Publicité
