Publicité
2.9.1 UNLOADING THE WATER FROM THE DISHWASHER'S TANK (DISPENSER)
•
Turn OFF (No 1 - Page 3) the power of the dishwasher
•
Empty the washing dispenser removing the overflow hose.
•
If the dishwasher is equipped with draining pump, follow the above mentioned steps and then press the
start button once in order to start the automatically 2 minutes draining program. (ATT: during the draining
program the door must remain closed.)
•
Remove the filter and clean it carefully with water.
•
Rinse the washing compartment to remove any dirt residues.
Then, reassemble the parts in reverse order. The appliance should never operate without a filter.
During non-operation, the door should remain half-open or completely open (in order to avoid odours).
2.9.2 REGULAR MAINTENANCE AND CLEANING WORKS
Regularly, you should remove the rotating arms and sprinkler, clean them carefully with water and reposition the
parts in reverse order. This work should be performed with great care.
PAY ATTENTION TO THE CORRECT POSITION OF FILTERS AND SPRINKLER!
Do not clean the sprinkler's injectors with tools or sharp objects.
You may clean the appliance with warm water and conventional cleaning aids. Rub with water and then let it dry.
The stainless steel parts should be treated with special means for steel and you should never clean them with
steel wire, brush, etc. Also, you should never let them touch the surface, since even the lightest contact with the
surfaces may cause rust formation.
You should use brushes made of polymer plastic or natural brushes or thin wire. You should take care to move
towards the smoothing direction, so that you will not scratch the surface. Finally, rinse with clean water and dry
thoroughly.
We remind you that corrosion (rust formation) on stainless steel surfaces is not created by itself, but rather due
to the use of improper cleaning aid (e.g. whitening or particularly caustic cleaning aid based on chlorine).
Following a particular period of use, calcium sediments are formed in the internal walls of the dispenser (due to
mineral particles in the water), which may affect the correct operation of the appliance. For this reason, regular
removing of salt formations is required.
We recommend letting this work (removing of salt formations) to be performed by specialized personnel (or by
an authorized local dealer who sold the appliance).
2.10 CUSTOMER SERVICE
If you face any problems during the use of your appliance, we kindly ask you to refer to our company (or to the
authorized local dealer who sold the appliance).
2.11 SPARE PARTS, ACCESSORIES AND COMPONENTS
All spare parts and components can be found in the authorized local dealer, who sold this appliance, or directly
in our company.
In case of claims or complaints, you should necessarily report the model and serial number of the appliance /
machine. These can be found on the label that is attached on the appliance.
www.combisteel.com
11
Publicité
