Publicité
PROBLEM
Motor operates, but pump does
not rotate
Items do not dry (dishes, glasses,
etc.)
If the damage is not caused due to any of the above reasons, you kindly ask you to refer to the authorized local
dealer who sold this appliance, or directly to the company.
NOTE: THE COMPANY RESERVES THE RIGHT TO CHANGE OR MODIFY ITS APPLIANCES WITHOUT PRIOR
NOTIFICATION.
2.13 ELECTRONIC MULTIPLE WASH PROGRAMS DISHWASHERS
(Special instructions for dishwashers with electronic timer)
1. Turn the main switch to the PROGRAM position. The corresponding pilot light will turn on.
2. The PROGRAM SELECTOR pilot light will start blinking.
3. Select the required program: STANDAR (2 min.), SHORT (1 min.) or INTENSIV (3 min).
4. The program will begin and the PROGRAM SELECTOR pilot light will remain on until the program has been
completed.
5. When the washing program is completed, the PROGRAM SELECTOR pilot light will start blinking again.
6. If the door is opened whilst the appliance is in operation, the program will be interrupted and the time zeroed.
7. In the electronic models with a drain hose, turn the main switch to the OFF position and then to the DRAINAGE
position. The corresponding pilot light will turn off and then on. Pull out the plastic waste pipe, close the door,
press and hold the START button for 3΄΄. The appliance will discharge the tank water in 2΄. The PROGRAM
SELECTOR pilot light that was blinking remains constantly on. When it starts blinking again, the discharge is
completed. Turn the main switch to the OFF position and put the plastic waste pipe back in its place.
NOTE: If the door is opened during the drainage, the operation will be interrupted. To restart the appliance, close
the door and press the START button again.
* the asterisk is a reference to the special instructions for dishwashers with electronic multiple wash programs
timer, see paragraph 2.13.
CAUSE
An object has jammed the pump
fin
Salts or detergent have been
petrified following non-operation
of the appliance
Compartment has no drying aid
Drying valve is faulty
Program switch is faulty
Rinsing arms do not Rotate
Basket does not rotate
www.combisteel.com
SOLUTION
Refer to the authorized local
dealer.... (As above)
Rotate the screw on the backside
of the motor, until it rotates freely
Insert drying aid to the
compartment
Refer to the authorized local
Dealer who sold the appliance or
directly to the manufacturer
13
Publicité
