Publicité
13. Troubleshooting
Fault
Possible cause
1. Power tool does
Power supply interrupted
not start
Power cord or plug defective
Other electrical defect of the power tool
2. Power tool does
Extension cord too long and/or cross-section too small
not operate with
full power
Power supply (e. g. generator) voltage too low
3. Poor operation
Sanding paper worn out
results
Abrasive plate worn out
4. Considerable dust
Brush edge (around the sanding disc) worn out
formation
Dust extraction not connected / switched on
Service information
Please note that the following parts of this product are subject to normal or natural wear and that the following parts are therefore also required
for use as consumables.
Wear parts*: Carbon brushes, grinding plates, brush head, sanding paper
* Not necessarily included in the scope of delivery!
20
GB/IE
Remedy
Check power supply by connecting another power tool
Electrician must check the tool
Electrician must check the tool
Use extension cord with permissible length and/or
adequate cross-section
Connect power tool to an appropriate power supply
Replace sanding paper
Replace abrasive plate by specialist
Replace brush edge by specialist
Connect / switch on dust extraction
Publicité
