Télécharger Imprimer la page

UFESA SIENNA Mode D'emploi page 24

Publicité

INSTRUCTIONS OF USE
At first use, rinse the internal circuit as follows:
Fill the water tank according to chapter 6. While plugging in, the appliance performs a
self-diagnosis cycle, indicated by 2 seconds flashing of the four buttons.
Press the on/off button, the '1-cup' and '2-cups' lights flash to indicate the appliance is
heating up. Press the steam button and turn on the steam knob to release the residual
air. Keep this operation last for 30 seconds at least when the machine is put in opera-
tion for the first time or after a long period of storage.
WARNING: The residual air inside may cause the machine not work properly!
Turn off the steam knob and press the on/off button for next step. Attach the filter
holder to the appliance.
Press the on/off button, place a container with a minimum capacity of 500 ml under
the boiler outlet and press the '1- cup' or '2-cups' button when the lights are steady.
Repeat this operation 5 times. The machine will turn off automatically if no operation
is performed within 30 minutes. You can press the ON/OFF button to start again.
ON/OFF
1-CUP
2-CUP
STEAM
STEAM/
ON/OFF
STEAM
HOT WATER
KNOB
HOW TO MAKE ESPRESSO COFFEE
1. How to make a hotter coffee
For making espresso coffee:
You are recommended to warm the cups before making coffee by rinsing them with
a little hot water. Attach the filter holder to the appliance with the filter in place but
without adding coffee powder.
Using the same cup as will later be used to make the coffee, press the one cup button,
and deliver hot water into the cup to heat it. Rest the cups you will be using on the cup
warmer which becomes hot during operation.
2. How to prepare espresso coffee using pre-ground coffee
Place the ground coffee filter in the filter holder. To make one coffee, use the filter with
the '1-cup' symbol on the bottom. To make two coffees, use the filter with the '2-cup'
symbol on the bottom. To make just one coffee, place one brim-full measure of pre-
ground coffee in the filter. To make two coffees, place two loosely filled measures of
pre-ground coffee in the filter. Fill the filter a little at a time to prevent the pre-ground
coffee from overflowing.
IMPORTANT: For correct operation, before filling with pre-ground coffee, make
sure there are no coffee residues left in the filter from the last time you made coffee.
24

Publicité

loading