Switching On - Stihl FSA 65 Notice D'emploi

English

Switching On

The battery is given a charge of about
30% before leaving the factory.
Recommendation: Fully charge the
battery before using your power tool for
the first time.
N If necessary, remove the cover from
the battery compartment before
fitting the battery, i.e. depress both
locking tabs to unlock and remove
the cover.
Fitting the battery
N Insert the battery (1) in the power
tool – the battery slides into the
compartment – press it down
carefully until it snaps into position –
the battery must be flush with the
top of the housing.
Switching On
N Make sure you have a secure and
balanced footing.
N Stand upright – hold the power tool
in a relaxed position.
14
N
Make sure the cutting attachment is
not touching the ground or any other
objects.
N Hold the unit with both hands – one
hand on the control handle – one
hand on the loop handle.
N Unlock the power tool by moving the
retaining latch (2) to ‚.
1
N Push down the trigger switch
lockout (3) and depress the trigger
switch (4) and hold them in that
position.
The motor runs only if the retaining
latch (2) is on ‚ and the trigger switch
lockout (3) and trigger switch (4) are
operated simultaneously.
Trigger Switch
Motor speed can be controlled with the
trigger switch. Motor speed is increased
progressively by squeezing the trigger
switch (FSA 85 only).
2
2
3
4
FSA 65, FSA 85