Adjusting Nylon Line; Connecting Charger To Power Supply; Charging The Battery - Stihl FSA 65 Notice D'emploi

English

Adjusting Nylon Line

Adjusting Nylon Line
N Hold the rotating mowing head
above the ground – tap it on the
ground once – about 3 cm fresh line
is advanced.
2
1
The blade (1) on the deflector (2) trims
surplus line to the correct length – avoid
tapping the mowing head more than
once at a time.
Line feed operates only if both lines still
have a minimum length of 2.5 cm.
If the line is shorter than 2.5 cm:
N Switch off the trimmer.
N Move the retaining latch to ƒ and
remove the battery.
N Turn the trimmer on its back.
N
Press down the cap on the spool as
far as stop.
N Pull the ends of the lines out of the
spool.
If the spool is empty, see "Replacing
Nylon Line".
10
Connecting Charger to
Power Supply
Mains voltage and operating voltage
must be the same.
N
Insert the mains plug (1) in the wall
outlet (2).
1
A self test is performed after the charger
is connected to the power supply. During
this process the light emitting diode (1)
on the charger lights up green for about
1 second, then red and goes off again.

Charging the Battery

The battery is given a charge of about
30% before leaving the factory.
Recommendation: Fully charge the
battery before using your power tool for
2
the first time.
1
N Connect the charger to the power
supply – mains voltage and
operating voltage of the charger
must be the same – see
"Connecting Charger to Power
Supply".
Operate the charger indoors only in dry
locations at an ambient temperature
between +5°C and +40°C.
N Push the battery (1) into the
charger (2) until you feel noticeable
resistance – then push it as far as
stop.
2
FSA 65, FSA 85