Publicité
IMPORTANT SAFEGUARDS
KNOW YOUR OMEGA JUICER
A
B
C
D1
D2
E
F
G
H
I
J
A
Pusher
B
Chute Lid
C
3-Inch Feed Chute
D1
2 Piece Auger (top)
D2
2 Piece Auger (bottom)
IMPORTANT SAFEGUARDS
BEFORE USING YOUR JUICER
Before using your Omega Juicer for the first time, remove any packaging material and
promotional labels. Wash pusher, feed chute, 2-piece auger, juice screen, chamber, pulp
container, and juice container with lid in warm, soapy water. Rinse and dry thoroughly.
The motor base can be wiped with a damp cloth. Dry thoroughly. See Cleaning and
Maintenance on page 11.
5
L- CONTROL INTERFACE
DIGITAL SCREEN
START BUTTON WITH 2 SPEED
FUNCTION (LOW / HIGH)
REVERSE
STOP/OFF
K
L
E
J
Juice Screen
Juice Container
F
Chamber
K
Motor Base
G
L
Pulp Outlet
Control Interface
H
Juice Outlet
I
Pulp Container
HOW TO ASSEMBLE YOUR JUICER
This product is equipped with dual safety system and will work only after all parts are
installed correctly. Please install and use the product according to the steps below:
1.
Place the motor base on a flat, dry surface.
2.
Before use, make sure the red silicone extraction seal at the bottom of the juice chamber is
firmly inserted into the pulp outlet.
3.
Place the juice chamber onto the motor base making sure that the anchor cavities are
properly inserted into the anchor columns in the motor base.
4.
Place the juice screen into the chamber, lining up the red dot with the triangle on the edge of
the auger chamber. Push down until the juice screen is fully inserted.
5.
Place the bottom of the 2-piece auger inside the juice screen. Turn it left and right making
sure it's properly inserted. Then place the top part of the 2-piece auger on top ensuring they
are properly assembled and connected.
NOTE:
When installing the 2-piece auger assembly, first align the notch of the crushing plate
on the 2 piece auger with the protrusion of the juicing screen and hold it, press down on the
wheel of the top auger part while slightly turning it until the notch of the crushing plate is
placed in the alignment slot of the juicing screen.
6.
Place the 3-inch wide feed chute onto the chamber. To securely lock the 3-inch wide chute
onto the chamber, align the triangle lock guide from the chute with the unlock icon on the
chamber base. Twist until the lock guide from the chute is perfectly aligned with the lock icon
on the chamber base.
NOTE:
Due to the safety locking structure of the feed chute, please keep the chute cover open
when installing the feed chute, otherwise the assembly cannot be completed!
7.
Once the juicer is assembled, close the chute lid and insert the pusher into the chute cover hole.
8.
Place the pulp container underneath the pulp outlet and the juice container underneath the
juice outlet.
9.
Plug the juicer into a power outlet.
1
2
6
7
3
4
5
8
9
6
Publicité
