Marking Door Panel Top Bracket Location(S) - Jenn-Air JB36NXFXLE Instructions D'installation

INSTALLATION

MARKING DOOR PANEL TOP BRACKET LOCATION(S)

A
C
A. Top of custom refrigerator door panel
B. Drilling template
C. Bottom of custom refrigerator door panel
14 | INSTALLATION
APPLIES TO:
6 ⁄ " (17.2 cm)
3
IMPORTANT: For an Armoire installation, instead
4
of drilling holes along the top edge(s) of the custom
door panel(s), you must adjust the placement of the
drilling template (provided with the refrigerator).
NOTES:
B
No template adjustment is needed for the bottom
■
edge of the door panel(s).
No template adjustment is needed for the custom
■
freezer drawer panel.
1.
2.
Align the drilling template on the back of the
custom refrigerator door panel so that the top of
the template is offset 6³⁄ " (17.2 cm) from the top
4
of the refrigerator door panel.
NOTE: The only offset dimension is the 6³⁄
(17.2 cm) offset from the top of the door panel.
Continue to use the template as you normally
would along the bottom, handle side of the door
panel.
"
4