Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SITE PREPARATION
BEFORE INSTALLATION
The Armoire-Style Door Panel Kit for fully integrated
JennAir
®
refrigerators enables door panels with a
hidden top panel for the ultimate integrated design in
kitchen cabinet.
IMPORTANT:
These instructions are intended as a
general guide only and do not supersede
any national or local codes in any way.
Compliance with all local, state, or national
codes pertaining to this type of installation
should be determined prior to installation.
These instructions are intended to
supplement the Installation Instructions
provided with your refrigerator, not replace
them. Follow the instructions provided with
the refrigerator to install it into the cabinet.
NOTE: The hardware bag contains all
the parts and fasteners needed to install
panels. A hardware bag is shipped with the
refrigerator. You will find the hardware bag in
either one of the crisper drawers or attached
to the outside of one of the refrigerator
doors.
CAUTION
Pinch Hazard
Installation of door panels with less than a ³⁄₈"
(0.95 cm) gap between the door panel and the
adjacent cabinet increases the risk of potential
pinching.
TOOLS AND PARTS REQUIRED
Assemble the required tools and parts before starting
installation. Read and follow the instructions provided
with any of the required tools listed here. Proper
installation is your responsibility.
Tools Required:
Cordless drill and drill bits
3/8" and 1/2" Open-end wrenches or two
adjustable wrenches
Phillips screwdriver
Small level
Appliance dolly
3/32", 5/32", and 3/16" Hex keys
1/4" and 5/16" Nut drivers
6" Extension nut drivers
Tape measure
TOOLS AND PARTS PROVIDED
Parts Supplied with Panel Kit:
Instructions
Grille Panel
Grille bracket assembly
W11215146 (for 36" models)
W11215152 (RH side)
W11215148 (for 42" models)
W11215154 (LH side)
W11215150 (for 48" models)
Foam air divider
W11239303
SITE PREPARATION | 5
Publicité
Chapitres
Table des Matières
