Installing Grille Bracket Assembly - Jenn-Air JB36NXFXLE Instructions D'installation

INSTALLATION

INSTALLING GRILLE BRACKET ASSEMBLY

APPLIES TO:
WARNING
Excessive Weight Hazard
1
Use two or more people to move and install
refrigerator.
Failure to do so can result in back or other
injury.
NOTE: If refrigerator is not on rollers, it is
recommended to lower the product to have more
access at the top of product for panel installation. For
ease of grille installation, it is recommended to have
product outside of kitchen cabinet not more than 8"
(20.32 cm).
1.
Remove the three screws fastening each
mounting plate to the top of the refrigerator on
2 each side. Discard the mounting plates but keep
the screws for attaching the two grille bracket
assemblies provided in this kit.
2.
Remove the two screws fastening the air divider
to the unit housing. Discard the air divider, and
reinstall the screws into the holes from where
they were removed.
3.
Align the three holes in a grille bracket assembly
with the three holes in a cabinet side, as shown.
Using the screws removed in Step 1, attach the
grille bracket assembly.
4.
Repeat step 3 to install the other grille bracket
assembly to the opposite side of the refrigerator.
IMPORTANT: Installing the Armoire-style door
panels before removing both existing factory
installed grille brackets can damage the panels.
3
Parts to be used:
X2 Grille bracket assembly
INSTALLATION | 11