BEA LZR-H100 Mode D'emploi page 7

1
MOUNTING & WIRING
Carefully read the application requirements and tips before mounting the sensor.
The mounting position of the sensor is crucial for the good functioning of the barrier.
1
Use a mounting post or a
mounting bracket to fix the sensor
on the pole.
4
Close the protection cover and
fasten it firmly.
+
GREEN
-
BROWN
WHITE
YELLOW
PINK
VIOLET
+
RED
-
BLUE
WHITE/RED
WHITE/BLUE
LED-signal at power-on:
correct positioning
is needed
2
Position the mounting bracket
and fasten the 4 screws firmly in
order to avoid vibrations.
5
Position the housing on the
mounting base.
POWER SUPPLY +
POWER SUPPLY -
RELAY 1 - OPENING FIELD
RELAY 2 - SAFETY FIELD
TEST +
TEST -
NOT USED
Power on without test No detection
signal: connect red +
blue to test or power
supply.
3
Open the protection cover, plug
the connector and position the
cable in the slit.
6
IN
Turn the sensor until the two
triangles are face to face.
Make sure you don't confuse
the white wire with the striped
wires (not used)
No test function: connect RED/GREEN
and BLUE/BROWN to power supply.
Polarity is important.
Safety &
opening detection
LOCK
7