BEA LZR-H100 Mode D'emploi page 14

HOW TO USE THE REMOTE CONTROL
After unlocking, the first LED
flashes red and the sensor
can be adjusted by remote
control.
ADJUSTING ONE OR MORE PARAMETERS
CHECKING A VALUE
RESTORING TO FACTORY VALUES
SAVING AN ACCESS CODE
The access code is recommended for sensors installed close to each other.
DELETING AN ACCESS CODE
Enter the existing code
X = NUMBER OF FLASHES = VALUE OF THE PARAMETER
x
14
If the red LED flashes quickly after unlocking, you
need to enter an access code from 1 to 4 digits.
To end an adjustment session,
always lock the sensor.
x
= field width: 4.2 m
4 1 2
= field width is defined by teach-in
3