BEA LZR-H100 Mode D'emploi page 6

DO's & DON'Ts (for EN 12453 safeguarding level E-conformity)
Install the sensor at a mounting height of 35 - 45 cm.
If the barrier is only used by trucks, the mouting height
can be increased.
Make sure to place the detection field parallel to
the boom.
When using the safety, place the sensor just
behind the barrier. This way the safety field
protects the area around the boom.
d (mm)
50
100
150
Keep the front face of the sensor free!
6
35 - 45 cm
l (mm) h (mm)
min
min
240 52
360 59
480 66
60 cm
If the reference beam is too low or too high, contact
with the boom cannot be excluded.
Do not position the detection field as shown.
B
A
When using the safety, do not place the sensor before
the barrier (A) or more than 40 cm after the boom (B).
The area around the boom is not safe.
Do not cover the front face of the sensor with glass
or plastic.