Publicité
DSPLY FMT=AM/PM – Selects how the time will be displayed on the front of the
unit. Using the UP or DOWN keys, select one of the following options:
1. AM/PM – Standard time (1-12 hours).
2. MIL – Military time (0-23 hours).
PRINT FMT=AM/PM – Selects how time will be printed on the time card. Using
the UP or DOWN keys, select one of the following options:
1. AM/PM – Standard time (default setting) (i.e. 3:30 PM).
2. MIL- Military time (i.e. 3:30 PM = 15:30).
3. ATAAP-Military time with minutes expressed in hundredths of hour (i.e.
3:30 PM = 15.50).
SET HOUR – Sets the current hour of day by using the UP or DOWN key.
SET MINUTES – Sets the current minute of day by using the UP or DOWN key.
BELL SET-UP
The internal buzzer is intended for quiet areas. To adjust the volume of the
internal buzzer, open the front cover and turn volume control on the left side of the
circuit board clockwise to increase volume or counter clockwise to decrease
volume.
External bells or buzzers can be added by purchasing a Model 5300 Bell Ringer.
The Bell Ringer can ring up to 15 bells or horns with 50 events. Please refer to
Optional Supplies and Accessories table located at the end of this booklet. To
connect the 5300 Bell Ringer to the 4000/4000HD Time Recorder, plug the RJ-45
cable into jack on the left side of the Time Recorder. Connect the other end of the
cable to the Model 5300. The wall transformer provided with the 5300 must be
connected to the recepticle labeled POWER. Wire your bells/ horns to the labeled
terminals on the 5300. The Bells/Horns must be wired in parallel as shown, not in
series:
5
Publicité
