Télécharger Imprimer la page

Kärcher OC 3 Foldable Mode D'emploi page 13

Masquer les pouces Voir aussi pour OC 3 Foldable:

Publicité

ATTENTION
Risk of damage if dry running!
Dry running damages the pump of the device.
Do not switch on the device if no water is present in the
water reservoir.
Switch off the device as soon as the water reservoir is
empty.
Switch off the device if it does not build up pressure
within 2 minutes. Then proceed according to the instruc-
tions in chapter Troubleshooting guide.
2. Press the ON/OFF button.
The device switches on.
Illustration H
CAUTION
Risk of injury from spray jet!
The spray jet may cause injury to eyes and ears.
Do not aim the spray jet at the eyes or ears of people or
animals.
3. Pull the trigger and carry out the cleaning process.
Note
Approx. 2 min before the end of the operating time (see
chapter Technical data), the operating status LED starts
flashing. Charge the battery as soon as possible, see
chapter Battery charging.
Interrupting operation
1. Release the trigger.
After another 30 minutes without being pressed, the de-
vice shuts off automatically.
Ending operation
1. Press the ON/OFF button.
The device switches off.
2. Empty out the water remaining in the water reser-
voir.
3. Press the ON/OFF button.
The device switches on.
4. Actuate the trigger until no more water is emitted.
5. Release the trigger.
6. Press the ON/OFF button.
The device switches off.
7. Allow the water reservoir to dry completely.
8. Press the water reservoir down to fold it and make it
smaller.
9. Stow the hose and the low-pressure gun in the water
reservoir.
10. Stow the charger and the charging cable in the wa-
ter reservoir.
11. Attach the lid to the water reservoir.
Transport
CAUTION
Risk of injury and damage
Be aware of the weight of the device during transporta-
tion.
ATTENTION
Risk of damage due to escaping water!
The lid of the water reservoir is not watertight, water es-
caping during transport can cause damage to property.
Carry the device with care if water is present in the wa-
ter reservoir.
Empty the water reservoir completely before transport-
ing the device in a vehicle.
1. Observe regulations for dangerous goods during
transport.
1. Lift up the device by the carrying handle, and carry
it.
Transport in vehicles
CAUTION
Risk of injury and damage!
There is a risk of injury and damage due to tipping and
sliding of the device during transport.
Before transporting the device in vehicles, secure it
against slipping and tipping over in accordance with the
applicable guidelines.
1. Finish operation, see chapter Ending operation.
2. Before transporting the device, stow it away or se-
cure it against sliding, tipping and being thrown
around.
CAUTION
Risk of injury and damage!
If the weight of the device is not observed, there is a risk
of injury and damage.
Be aware of the weight of the device during storage.
ATTENTION
Risk of damage due to frost!
An incompletely emptied device can be damaged by
frost.
Completely empty the device and accessories before
storing them.
Protect the device from frost.
Store the device in a frost-free place and not outdoors.
1. Finish operation, see chapter Ending operation.
2. Place the device in a closed room on a flat surface
and store it within the permitted ambient tempera-
ture, see chapter Technical data.
Care and service
DANGER
Touching live parts
Danger of injury from electric shock
Switch off the device and unplug the charger from the
device before performing any work on the device.
Cleaning the fine filter
Clean the fine filter regularly.
ATTENTION
Risk of damage due to improper cleaning!
The fine filter is damaged by improper cleaning.
Clean the fine filter only under running water against its
flow direction.
Do not use sharp or hard objects such as needles or
wire brushes.
1. Drain the water reservoir.
2. Pull out the fine filter.
Illustration I
3. Clean the fine filter with clean, clear running water.
4. Fit the fine filter into the device.
Troubleshooting guide
DANGER
Touching live parts
Danger of injury from electric shock
Switch off the device and unplug the charger from the
device before performing any work on the device.
Have repair work and work on electrical components
carried out by the authorised customer service only.
English
Manual transport
Storage
13

Publicité

loading