voestalpine Bohler Welding URANOS NX 2700 TLH Mode D'emploi page 30

SETUP
Coolant flow reading
EN
Coolant temperature reading
3
1
2
Parameter selection
Select the required parameter (801).
Parameter selection
Mode selection
Absolute value
4
Warning limits line
1
Alarm limits line
2
Minimum levels column
3
Maximum levels column
4
Select the required box by pressing the encoder key (the selected box is displayed
with reverse contrast).
Adjust the level of the selected limit by rotating the encoder.
Passing one of the warning limits causes a visual signal to appear on the
control panel.
Passing one of the alarm limits causes a visual signal to appear on the control
panel and the immediate blockage of the welding operations.
It is possible to set start and end of welding filters to prevent error signals
during the striking and extinction of the arc (consult the "Set up" section -
Parameters 802-803-804).
Wire speed reading
.
30
.
.
Percentage value