voestalpine Bohler Welding URANOS NX 2700 TLH Mode D'emploi page 24

SETUP
Bilevel current
8
Permits adjustment of the secondary current in the bilevel welding mode.
EN
At the first release there is the ramp to go up to the current "I1".
Minimum
3 A
Basic current
10
Permits adjustment of the base current in pulsed and fast pulse modes.
Minimum
3 A
Pulsed frequency
12
Allows activation of the pulse mode.
Minimum
0.1 Hz
Pulsed duty cycle
13
Allows regulation of the duty cycle in pulse welding.
Allows the peak current to be maintained for a shorter or longer time.
Minimum
1 %
Fast Pulse frequency
14
Allows activation of the pulse mode.
Minimum
0.02 KHz
Pulsed slopes
15
welding arc.
Minimum
0/off
Slope-down
16
Allows you to set a gradual passage between the welding current and the final current.
Minimum
0/off
Final current
17
Permits adjustment of the final current.
Minimum
3 A
Final current time
19
Makes it possible to set the time for which the final current is maintained.
Minimum
0/off
Post-gas
20
Minimum
0/off
Maximum Default
Imax -
Maximum Default
Isald -
Maximum Default
25 Hz 5 Hz
Maximum Default
99 % 50 %
Maximum Default
2.5 KHz 0.25 KHz
Maximum Default
100 % 0/off
Maximum Default
99.9 s 0/off
Maximum Default
Imax 10 A
Maximum Default
99.9 s 0/off
Maximum Default
99.9 s syn
Minimum Maximum
1% 500%
Minimum Maximum
1% 100%
Minimum Maximum
1 % 200 %
24
Default
off
Default
50%
Default
50 %