voestalpine Bohler Welding URANOS NX 2700 TLH Mode D'emploi page 21

Selection and adjustment of the required parameter
Rotate the encoder until you display the numerical code for the required parameter.
If the encoder key is pressed at this point, the value set for the parameter selected can be displayed and adjusted.
Exit from set up
To quit the "adjustment" section, press the encoder again.
To exit the set-up, go to parameter "0" (save and quit) and press encoder key.
To save the change and exit the set up, press the key:
5.1.1 List of set up parameters (MMA)
Save and Exit
0
Allows you to save the changes and exit the set up.
Reset
1
Allows you to reset all the parameters to the default values.
Hot start
3
Allows adjustment of the hot start value in MMA.
Permits an adjustable hot start in the arc striking phases,facilitating the start operations.
Basic electrode
Minimum
0/off
CrNi electrode
Minimum
0/off
Cast Iron electrode
Minimum
0/off
Welding current
7
Allows the regulation of the welding current.
Minimum
3 A
Arc force
8
Allows adjustment of the Arc force value in MMA.
Permits an adjustable energetic dynamic response in welding, facilitating the welder's operations.
Increase the value of the Arc force to reduce the risk of electrode sticking.
Basic electrode
Minimum
0/off
CrNi electrode
Minimum
0/off
Cast Iron electrode
Minimum
0/off
.
.
Maximum Default
500% 80%
Maximum Default
500% 100%
Maximum Default
500% 100%
Maximum Default
Imax 100 A
Maximum Default
500% 30%
Maximum Default
500% 30%
Maximum Default
500% 70%
Cellulosic electrode
Minimum Maximum
0/off 500%
Aluminum electrode
Minimum Maximum
0/off 500%
Rutile electrode
Minimum Maximum
0/off 500%
Cellulosic electrode
Minimum Maximum
0/off 500%
Aluminum electrode
Minimum Maximum
0/off 500%
Rutile electrode
Minimum Maximum
0/off 500%
21
SETUP
EN
Default
150%
Default
120%
Default
80%
Default
350%
Default
100%
Default
80%