voestalpine Bohler Welding URANOS NX 2700 TLH Mode D'emploi page 25

Tig start (HF)
203
Allows selection of the required arc striking modes.
Value
on
off
Spot welding
204
Allows you to enable the "spot welding" process and establish the welding time.
Allows the timing of the welding process.
Minimum
0/off
Restart
205
Allows the activation of the restart function.
Allows the immediate extinguishing of the arc during the down slope or the restarting of the welding cycle.
Value
0/off
1/on
2/of1
Easy joining
206
Allows striking of the arc in pulsed current and timing of the function before the automatic reinstatement of the
pre-set welding conditions.
Allows greater speed and accuracy during tack welding operations on the parts
Minimum
0.1 s
Microtime spot welding
208
Allows you to enable the "microtime spot welding" process.
Allows the timing of the welding process.
Minimum
0.01 s
Welding speed
399
Lets you set welding speed.
Default cm/min: reference speed for manual welding.
Syn: Sinergic value.
Minimum
2 cm/min
500
Allows the selection of the required graphic interface.
Allows access to the higher set-up levels.
Refer to section "Interface personalisation (Set up 500)"
Value
USER
SERV
vaBW
Lock/unlock
551
Allows the locking of the panel controls and the insertion of a protection code.
Refer to section "Lock/unlock (Set up 551)".
Buzzer tone
552
Permits adjustment of the buzzer tone.
Minimum
0/off
Default Callback function
X HF START
- LIFT START
Maximum Default
99.9 s 0/off
Default Callback function
- off
X on
- off
Maximum Default
25.0 s 0/off
Maximum Default
1.00 s 0/off
Maximum Default
200 cm/min 10 cm/min
Selected level
User
Service
vaBW
Maximum Default
10 10
Value User interface
XE Easy Mode
XA Advanced Mode
XP Professional Mode
25
SETUP
EN