voestalpine Bohler Welding URANOS NX 2700 TLH Mode D'emploi page 26

SETUP
Regulation step
601
Allows the regulation of a parameter with a step that can be personalised by the operator.
EN
Minimum
1
External parameter CH1, CH2, CH3, CH4
602
Allows the management of the external parameter 1, 2, 3, 4 (minimum value, maximum value, default value,
parameter selected).
Refer to section "External controls management (Set up 602)".
U/D torch
606
Allows the management of the external parameter (U/D).
Value
0/off
1/I1
612
It allows the management of the channels of the digital torch.
Value
0/off
1/I1
2/
3/CH3
4/CH4
5/STD
Circuit resistance calibration
705
Allows the calibration of the system.
Refer to section "Circuit resistance calibration (set up 705)".
Current reading
751
Allow the real value of the welding current to be displayed.
Voltage reading
752
Allows the real value of the welding voltage to be displayed.
Robot movement speed
758
Allows the arm movement speed of a robot or an automation device to be displayed.
Coolant flow reading
764
Allow the value of the coolant flow reading.
Coolant temperature reading
765
Allow the real value of coolant temperature reading to be displayed.
HI heat input measurement
768
Allows reading of the value of the measurement of the heat input in welding.
EN 1011-1
Maximum Default
Imax 1
Default Callback function
- off
X Current
- Program retrieval
Default Callback function
- off
- Current
- Program retrieval
- CH3
- CH4
X STD
26