voestalpine Bohler Welding URANOS NX 2700 TLH Mode D'emploi page 28

SETUP
XP MODE
EN
Welding parameters
Functions
Welding parameters
Functions
5.2.3 Lock/unlock (Set up 551)
Allows the locking of the panel controls and the insertion of a protection code.
MMA
TIG
Parameter selection
Select the required parameter (551).
Set a numerical code (password) by rotating the encoder.
Confirm the operation by pressing the encoder key.
Control panel functions
The carrying out of any operation on a locked control panel causes a
special screen to appear.
Access the panel functionalities temporarily (5 minutes) by rotating the encoder
and entering the correct password.
Confirm the operation by pressing the encoder key.
Unlock the control panel definitively by entering set-up (follow the instructions
given above) and bring back parameter 551 to "off".
Confirm the operation by pressing the encoder key.
28
.
.
.