Publicité
Cleaning work producing in oily waste water, e.g.
washing engines, washing undercarriages etc.,
may only be performed at washing stations with an oil
separator.
Working with detergents may only be performed on
watertight surfaces with connection to the waste
water sewage system. Do not allow detergent to enter
waterways or the soil.
Extraction of water from public waterways is not
permitted in some countries.
Notes on the content materials (REACH)
Current information on content materials can be found
at: www.kaercher.de/REACH
Intended use
Use the high-pressure cleaner in private households
only.
The high-pressure cleaner is intended for cleaning ma-
chines, vehicles, buildings, tools, façades, terraces,
garden machines etc. using a high-pressure water jet.
Accessories and spare parts
Only use original accessories and original spare parts.
They ensure that the appliance will run fault-free and
safely.
Information on accessories and spare parts can be
found at www.kaercher.com.
Scope of delivery
The scope of delivery for the appliance is shown on the
packaging. Check the contents for completeness when
unpacking. If any accessories are missing or in the
event of any shipping damage, please notify your deal-
er.
Device description
For the figures, please refer to the graphics page
Illustration A
Water connection coupling
1
Water connection with integrated sieve
2
High-pressure connection
3
Trigger "0/OFF" / "I/ON"
4
Mains connection cable storage compartment
5
Carrying handle
6
High-pressure hose storage compartment
7
Storage for high-pressure gun
8
Storage for spray lance
9
Mains connection cable with mains plug
10
Clamp for mains connection cable
11
High-pressure hose
12
High-pressure gun
13
Clamp for connecting / disconnecting the high-pres-
14
sure hose
High-pressure gun lock
15
Vario Power spray lance for common cleaning tasks
16
The working pressure can be continuously in-
creased from "SOFT" to "HARD". To adjust the
working pressure, release the trigger gun lever and
turn the spray lance to the desired position. Deter-
gent can be added to the water jet when the spray
lance is turned all the way in the SOFT direction.
Spray lance with dirt grinder for stubborn soiling
17
eco!booster spray lance
18
eco!booster nozzle
19
Washing brush
20
Foam nozzle with detergent tank
21
*Garden hose (fabric reinforced, diameter at least
22
1/2 inch (13 mm), length at least 7.5 m, with com-
mercially available quick coupling)
* additionally required
For the figures, please refer to the graphics page.
Fit the supplied loose parts onto the device before start-
ing up the device.
Installing the water connection coupling
1. Screw the water connection coupling onto the water
connection on the device.
Illustration B
1. Place the device on a flat and level surface.
2. Unwind the high-pressure hose and eliminate any
loops and twists.
3. Connect the high-pressure hose to the device.
a Pull up the clamp on the coupling.
b Insert the high-pressure hose into the coupling.
c Press down the clamp on the coupling.
Illustration C
4. Connect the high-pressure hose to the high-pres-
sure gun.
a Squeeze the clamp.
b Pull out the clamp.
c Insert the high-pressure hose.
d Press the clamp in until it latches into place.
Illustration D
5. Check for a secure connection by pulling on the
high-pressure hose.
6. Plug the mains plug into a mains socket.
For the connection values, see the type plate or chapter
Technical data.
Observe the water distribution company regulations.
ATTENTION
Damage through contaminated water
Contamination in the water can damage the pump and
the accessories.
KÄRCHER recommends using the KÄRCHER water fil-
ter for protection(special accessory, order number
4.730-059).
Connection to the water line
ATTENTION
Risk of damage!
Damage to the pump when using a hose coupling with
aquastop on the water connection of the device.
Do not use a hose coupling with aquastop on the water
connection of the device.
Use a hose coupling with "aquastop" on the tap only.
English
Mounting
Initial startup
Water supply
9
Publicité
