Publicité
4
Installation Procedure
Usage
Tab. 2
RIF.
SIGNAL
1
HV1 Connector
2
HV2 Connector
3
LINE INPUT
4
FUSE
5
SERIAL Connector
6
REMOTE Connector
7
HV1 Cable Interlock
8
HV2 Cable Interlock
Usage
This paragraph gives a general information on the use of the
controller. For details refer to the "Technical Information"
paragraph. When the controller is plugged to the Power Line and the
Line Switch on the rear panel is ON (I), it is able to operate with its
full set of features:
66/104
HV Connector for Cable to Ion Pump 1
HV Connector for Cable to Ion Pump 2
Module containing the Line Input cable plug and the Line Switch
Protection Fuse holder (2 fuses)
DB9 connector for the Serial cable
DB25 connector for the REMOTE I/O connections
2 independent HV channels
+5000 Vdc maximum output Voltage
40 W maximum output Power for channel 1
80 W maximum output Power for channel 2
>30 mA maximum output current (short circuit condition) for
channel 1
>60 mA maximum output current (short circuit condition) for
channel 2
LOCAL-REMOTE I/O/SERIAL operating mode
START/PROTECT operation
Ion Pumps Control Unit User Manual / 87-900-124-01
DESCRIPTION
(C)
Publicité
Chapitres
